Quality Matthews GA septic system installers do a great deal of examination, long before a unit gets placed into the ground. A brand new unit will last many years, and possibly even generations, if it’s placed the right way, but it can fall short instantly if it’s not. On top of that, all Matthews GA septic system installers must secure a permit for them to perform the install, and may need to work with city or county officials to show that certain tests were performed in order to continue. These three assessments are important primary steps that should always be taken before any work or designs are done, and it may also be advantageous to perform them before you buy a property, so you could be assured that a tank and leach field will be permitted.
1. Pit
The pit test is relatively direct. During the course of this test, a hole is dug and the soil is analyzed to establish its composition. A conventional leach field is dependent on the soil’s composition to drain effectively. If there is a considerable amount of gravel or sand, your leach field should be ready to discharge the effluent (water) from the tank well, where the soil will finish sanitizing it. If the soil has a considerable amount of clay or rock, it won’t sink well, consequently a conventional leach field will not be an alternative. If the site you’ve picked does not pass the pit test, you may be able to choose another site on your property or use an alternate kind of drain field, such as a mound system.
2. Perc
The perc, or percolation test, requires excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then saturating it with water. The hole is generally left drenched for about two hours, and topped off as needed. After this, the hole is filled with 6 inches of water and observed for drainage.
3. Visual
There are many things an inspector will look into visually. A lot of units are gravity-fed, so they don’t rely on electricity or pumps to shift effluent from the tank to the leach field. As a result of this, the slope of the ground is crucial. An inspector will also try to find inclines that could possibly feed excess water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Enlist the Services of Quality Matthews GA Septic System Installers Today
Picking the right configuration, type of system, and evaluating the land properly, are all essential procedures in making sure an install goes off without a hitch. Most significantly, these steps ensure that the install is done correctly, so that a system provides years of use without issue. If you’re preparing for an install, contact Septic Tank Pros Augusta GA. Our partner specialists are knowledgeable and dedicated to quality, so you could be sure the job is done right. Call (706) 204-1717 today.