Quality Camak GA septic system installers do a lot of legwork, long before a unit gets put into the ground. A brand new unit will last many years, and possibly even generations, if it’s set up correctly, but it can fail instantaneously if it’s not. On top of that, all Camak GA septic system installers must secure a permit for them to carry out the install, and may ought to coordinate with city or county officials to show that specific tests were done in order to progress. These three evaluations are necessary first steps that should always be taken before any work or designs are done, and it may also be helpful to do them before you acquire a property, so you can be assured that a tank and leach field will be permitted.
1. Pit
The pit test is fairly direct. In the course of this test, a hole is dug and the soil is inspected to figure out its structure. A typical leach field is reliant on the soil’s composition to drain successfully. If there is a lot of gravel or sand, your leach field should be capable to discharge the effluent (water) from the tank well, where the soil will finish sanitizing it. If the soil has a lot of clay or rock, it won’t drain well, and so a traditional leach field will not be an option. If the site you’ve selected does not pass the pit test, you may be able to select another site on your house or use an alternate kind of drain field, like a mound system.
2. Perc
The perc, or percolation test, requires excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then filling it with water. The hole is commonly left drenched for about two hours, and topped off as needed. Then, the hole is filled with 6 inches of water and monitored for drainage.
3. Visual
There are many things an inspector will investigate visually. Most units are gravity-fed, so they don’t depend on electricity or pumps to shift effluent from the tank to the leach field. Because of this, the slope of the ground is important. An inspector will also seek out slopes that could feed excess water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Hire Quality Camak GA Septic System Installers Today
Choosing the right design, type of system, and assessing the land effectively, are all integral steps in making sure an install goes off without a hitch. Most importantly, these steps guarantee that the install is done correctly, so that a system provides years of use without problems. If you’re prepping for an install, call Septic Tank Pros Augusta GA. Our partner service technicians are knowledgeable and dedicated to quality, so you can be sure the job is done right. Call (706) 204-1717 right now.