Quality Blythe GA septic system installers do a lot of examination, long before a unit gets installed into the ground. A new unit will last years, and possibly even generations, if it’s placed correctly, but it can fail immediately if it’s not. On top of that, all Blythe GA septic system installers must obtain a permit for them to perform the install, and may will have to partner with city or county officials to show that a number of tests were run in order to proceed. These three evaluations are vital primary steps that should always be taken before any job or designs are done, and it may also be helpful to do them before you buy a property, so you could be assured that a tank and leach field will be allowed.
1. Pit
The pit test is very straightforward. During the course of this test, a hole is excavated and the soil is analyzed to figure out its structure. A typical leach field is reliant on the soil’s structure to drain successfully. If there is a lot of gravel or sand, your leach field should be able to discharge the effluent (water) from the tank well, where the soil will finish sanitizing it. If the soil has a bunch of clay or rock, it won’t sink well, consequently a traditional leach field will not be an alternative. If the location you’ve picked does not successfully pass the pit test, you may be able to pick another site on your home or use an alternate kind of drain field, such as a mound system.
2. Perc
The perc, or percolation test, involves excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then filling it with water. The hole is generally left soaked for about two hours, and topped off as needed. After this, the hole is filled with 6 inches of water and monitored for drainage.
3. Visual
There are a variety of things an inspector will check visually. The majority of units are gravity-fed, so they don’t depend on electricity or pumps to shift effluent from the tank to the leach field. As a result of this, the incline of the ground is essential. An inspector will also seek out inclines that can feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Choose Quality Blythe GA Septic System Installers Now
Selecting the right design, kind of system, and evaluating the land correctly, are all integral steps in making sure an install goes off without a hitch. Most significantly, these steps ensure that the install is done properly, so that a system provides decades of use without issue. If you’re prepping for an install, contact Septic Tank Pros Augusta GA. Our partner professionals are experienced and dedicated to quality, so you could be sure the job is done right. Call (706) 204-1717 now.