Quality Mitchell GA septic system installers do a number of examination, long before a unit gets installed into the ground. A new unit will last decades, and possibly even generations, if it’s installed the right way, but it can break down instantly if it’s not. On top of that, all Mitchell GA septic system installers must secure a permit in order to execute the install, and may ought to collaborate with city or county officials to show that specific tests were run in order to move on. These three assessments are important initial steps that should always be taken before any task or designs are done, and it may also be beneficial to accomplish them before you buy a property, so you can be assured that a tank and leach field will be permitted.
1. Pit
The pit test is relatively uncomplicated. During the course of this test, a hole is dug down and the soil is analyzed to figure out its composition. A typical leach field is dependent on the soil’s structure to drain successfully. If there is a lot of gravel or sand, your leach field should be ready to discharge the effluent (water) from the tank well, where the soil will finish sanitizing it. If the soil has a considerable amount of clay or rock, it won’t drain well, consequently a standard leach field will not be an option. If the site you’ve chosen does not pass the pit test, you may be able to pick another site on your property or use an alternate kind of drain field, like a mound system.
2. Perc
The perc, or percolation test, consists of excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then saturating it with water. The hole is typically left saturated for about two hours, and topped off as needed. Then, the hole is filled with 6 inches of water and observed for water drainage.
3. Visual
There are numerous things an inspector will check into visually. Most units are gravity-fed, so they don’t rely on electricity or pumps to shift effluent from the tank to the leach field. As a result of this, the slope of the ground is crucial. An inspector will also search for slopes that could possibly feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Enlist the Services of Quality Mitchell GA Septic System Installers Today
Choosing the right layout, style of system, and evaluating the land effectively, are all fundamental steps in making sure an install goes off without a hitch. Most importantly, these steps ensure that the install is done correctly, so that a system provides decades of use without problems. If you’re prepping for an install, contact Septic Tank Pros Augusta GA. Our partner service technicians are skilled and committed to quality, so you can be sure the job is done right. Call (706) 204-1717 now.